Pax Invaders Flashover Assembly Instructions
These instructions are for the Pax Invaders Flashover kit for the R*MIL MEN toy line.
TOOLS NEEDED:
-
Hobby Clippers (for cleaning and removing support bits)
-
Superglue (in case of broken pieces or if some parts are too loose)
PARTS NEEDED IN THESE STEPS:
-
The parts used for this kit are all from the single Flashover sprue.
-
Snap in a rotation bar to the fuselage as shown.
-
Repeat on the other side.
-
Insert ratchet mechanism to inside of Left engine as shown. Note the side with grooves are facing outside.
-
Insert Left engine to rotation bar as shown, all the way until it is resting against the fuselage.
-
Repeat for the Right engine by inserting the ratchet mechanism similarly to the Left side and inserting it onto the rotation bar as shown.
-
Snap on the hood to the fuselage as shown.
-
Insert a flap into the right pontoon as shown. It must seat all the way inside and the flap must be able to rotate in place.
-
Insert a mounting peg into the Right pontoon arm as shown.
-
Insert the assembled pontoon into the right engine as shown.
-
Repeat for the other side by inserting the flap and mounting peg into the Right pontoon then inserting it into the Right engine similarly as above. Your Flashover is now complete.
-
The Flashover is in hover mode, to transform into Walker mode, first flip up both flappers on the pontoons as shown.
-
Rotate the pontoons down as shown.
-
The Flashover should balance on a flat surface with pontoons acting as legs.
-
If you have further kits to assemble, return to the R*MIL MEN main menu for assembly instructions.
